Wooden floors often get damaged the most when it comes to water damage. A flood, a busted water pipe, any gradual plumbing leak or even an overflow upstairs can cause significant water damage to your house. Therefore, you should follow extra preventive care for your flooring. Take a look on this http://247restorationatlanta.com/water-damage/ If water damage happens inspite of all this, you should be mitigating it by following this simple guide.
- Start by accommodating ample air circulation in the house. This shall help dry the floor. Open all the doors and windows and let air come in. If the climate is humid or if the floor was damaged because of a flood, it might not be practical to open the windows. Use a dehumidifier, a fan or even heater to dry the floor. Just try to make sure that the floor dries as soon as possible.
- In case of serious flooding, you should be removing all wet insulation that is placed between the joists and also place dehumidifiers and fans under the floor so that they can be dried as well. You can even use a solution of 10 percent bleach mixed with water to avoid mildew growth in this region before you finally dry it.
- You should be pulling out the baseboard from the floor and then letting it dry at another place. You will have to provide the necessary space for ventilation. So removing the baseboard from the perimeter of the wood floor will be a good option.
- Wait for the wood to dry. The normal moisture content of the wood should never be more than 20 percent. Let it dry well before you perform any other repair work on the wood. Make sure that there are no signs of rotting in the wood.
- You should be replacing all the boards that were previously lifted by you for drying. You can sand the floor lightly. It is quite possible that waterlogging in the wood caused its edges to swell up. Sanding will help fit the wood blocks and boards properly on the floor.
- Wait for a few more weeks and then sand the floor again. Use mineral spirits and wipe the floor clean. Now, you should be cleaning the surface completely and then coat it with varnish.
- Replace the insulation of the floor as well. You should be good to go. Keep checking for any signs of mold and mildew development in the floor and make sure that no further water damage is caused to the floor.